Files
MeltMind/docs/claude/s2-design-v0.1a-2026-11-14.md
T

22 lines
1.5 KiB
Markdown
Raw Blame History

This file contains ambiguous Unicode characters
This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.
# S2 design v0.1a: replaces v0.1 sections D (stop rule) and E (thin slice) (Claude, 2026-11-14)
Source: MoldAstra's D/E review (Drive 18X07uNtM1j697MCztXryzmITCcud3_T4). Accepted.
## D, replaced
- Withdrawn: "1 % volume per step → about 1 % label time resolution → 2 % non-identifiability stop".
- A volume step limit does not bound time resolution: a 1 % volume step can span a large share of total time.
- Even under constant flow, there is no positive lower bound on node write-out or interpolation error, nor on relative L2.
- No mandatory stop. In its place:
- Report R2's absolute source-equal relative L2 next to every E vs N result.
- The six-region decision table alone decides E vs N.
- If a later independent engineering basis justifies a budget stop line, it must be pre-registered before the pilot. When it triggers, the result reads "E−N not tested".
## E, replaced
- **Primary slice:** commonly eligible nodes with 0 < d/t_part ≤ 0.25 (the near-wall layer).
- **Thin-feature slice (MoldAstra definition):**
- For each boundary face, march along the inward normal from the face centroid to the first exit from the cavity.
- Keep faces whose ray hits an opposing wall with chord < t_part.
- Select near-wall nodes within a true tet-edge path distance ≤ 2·t_part of those faces.
- Until this mask is validated, report only the near-wall slice, with "unknown" counted separately.
- Connectivity-violation (bottleneck) metric: unchanged from v0.1.