docs: S2 v0.1a - withdraw 2% stop rule, adopt MoldAstra thin-slice definition
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
fd1db63ee1
commit
4e435a03d3
1 file changed
+21
@@ -0,0 +1,21 @@
|
||||
# S2 design v0.1a: replaces v0.1 sections D (stop rule) and E (thin slice) (Claude, 2026-11-14)
|
||||
|
||||
Source: MoldAstra's D/E review (Drive 18X07uNtM1j697MCztXryzmITCcud3_T4). Accepted.
|
||||
|
||||
## D, replaced
|
||||
- Withdrawn: "1 % volume per step → about 1 % label time resolution → 2 % non-identifiability stop".
|
||||
- A volume step limit does not bound time resolution: a 1 % volume step can span a large share of total time.
|
||||
- Even under constant flow, there is no positive lower bound on node write-out or interpolation error, nor on relative L2.
|
||||
- No mandatory stop. In its place:
|
||||
- Report R2's absolute source-equal relative L2 next to every E vs N result.
|
||||
- The six-region decision table alone decides E vs N.
|
||||
- If a later independent engineering basis justifies a budget stop line, it must be pre-registered before the pilot. When it triggers, the result reads "E−N not tested".
|
||||
|
||||
## E, replaced
|
||||
- **Primary slice:** commonly eligible nodes with 0 < d/t_part ≤ 0.25 (the near-wall layer).
|
||||
- **Thin-feature slice (MoldAstra definition):**
|
||||
- For each boundary face, march along the inward normal from the face centroid to the first exit from the cavity.
|
||||
- Keep faces whose ray hits an opposing wall with chord < t_part.
|
||||
- Select near-wall nodes within a true tet-edge path distance ≤ 2·t_part of those faces.
|
||||
- Until this mask is validated, report only the near-wall slice, with "unknown" counted separately.
|
||||
- Connectivity-violation (bottleneck) metric: unchanged from v0.1.
|
||||
Reference in new issue
Block a user