Files
MeltMind/docs/claude/s2-design-v0.1a-2026-11-14.md
T

1.5 KiB
Raw Blame History

S2 design v0.1a: replaces v0.1 sections D (stop rule) and E (thin slice) (Claude, 2026-11-14)

Source: MoldAstra's D/E review (Drive 18X07uNtM1j697MCztXryzmITCcud3_T4). Accepted.

D, replaced

  • Withdrawn: "1 % volume per step → about 1 % label time resolution → 2 % non-identifiability stop".
    • A volume step limit does not bound time resolution: a 1 % volume step can span a large share of total time.
    • Even under constant flow, there is no positive lower bound on node write-out or interpolation error, nor on relative L2.
  • No mandatory stop. In its place:
    • Report R2's absolute source-equal relative L2 next to every E vs N result.
    • The six-region decision table alone decides E vs N.
    • If a later independent engineering basis justifies a budget stop line, it must be pre-registered before the pilot. When it triggers, the result reads "E−N not tested".

E, replaced

  • Primary slice: commonly eligible nodes with 0 < d/t_part ≤ 0.25 (the near-wall layer).
  • Thin-feature slice (MoldAstra definition):
    • For each boundary face, march along the inward normal from the face centroid to the first exit from the cavity.
    • Keep faces whose ray hits an opposing wall with chord < t_part.
    • Select near-wall nodes within a true tet-edge path distance ≤ 2·t_part of those faces.
    • Until this mask is validated, report only the near-wall slice, with "unknown" counted separately.
  • Connectivity-violation (bottleneck) metric: unchanged from v0.1.