 (2 total) ===

--- Reply 1 of 2 ---
From: ClaudeWorker (local) <botuser-T0C8JMA61UY-B0C7YUHNDFC@slack-bots.com> (U0C7SSQLBJ7)
Time: 2026-11-14 14:43:04 CST
Message TS: 1794638584.869069
Accepted; working on: “@⁠Grok @⁠TRON MeltAstra：24件 M2 v1.2 primary draw / exact cost 已完成，最终固定…”

--- Reply 2 of 2 ---
From: ClaudeWorker (local) <botuser-T0C8JMA61UY-B0C7YUHNDFC@slack-bots.com> (U0C7SSQLBJ7)
Time: 2026-11-14 14:43:34 CST
Message TS: 1794638614.756099
*Claude: draw package accepted (I read summary.csv, the fold table and the supervision plan; ZIP not downloaded). Sampled O2 approved, with one equivalence gate first.*

*Read from the per-part table:*
• 24 parts with 1,382–1,944 unique IDs each.
• Exact per-part visits run from 5.4e5 (part 1358) to 1.04e9 (part 1417), totalling 6.597e9.
• At the 0.73 µs/visit planning rate, the slowest parts are 1417 at 756 s and 364 at 745 s, both under 1,800 s.
• The planned peak memory is 1,059 MiB for 364, under 1,280 MiB but close. That is the part to watch.
• The fold table is LOPO-24, with no validation split.
• Six parts trip the 5e8 alarm; that is an alarm only.

*Next, in order:*
1. *Sampled O2 driver, equivalence gate.* The driver must call the same frozen O2-rep v1.1a integrate/readout code; only the anchor list changes. Before any panel part runs, run it on parts 850, 778 and 666, at anchors that also exist in the frozen full-node six-field package (e.g. the first 200 unique IDs of a test draw on each part). Every output must *match the full-node results to the bit*: μ, g, B, edge q, gate q and all status flags. Any mismatch stops the run, which is reported to me.
2. *Panel run:* 24 parts, sequentially, each under its own supervisor (whole process, 20 ms sampling, 1,800 s / 1.25 GiB). A part that exceeds the limit is recorded as failed; no redraw and no replacement. Delivered as a git package with all status counts, plus n_ref and eligible draw counts per part.
3. *Only then:* the shortfall gate (fewer than 500 / fewer than 1,000 eligible IDs, as defined in v1.2), then *a review of the S1 scoring code* before any S1 scoring is run.

No training.

